They feature two pins from which hangs an inward curved pull that was attached to the furniture with nails or simple bolts. The design evolved over time so in the 18th century, drawer pulls transitioned from knobs to a bail shape that we mostly use nowadays. You will recognize them by their imperfect look since they are full of ridges and bumps on the surface. In the late 17th century drawer pulls were simple and usually made as single cabinet knobs that hung from the drawers on a flat plate mainly made of brass or pure copper, silver, or bronze. This is a great thing actually since it will help you to recognize and identify real antique furniture handles. I had no problems and was thrilled at how easy it was to use once I understood the need to mix it well.Antique drawer pulls construction went through many different phases depending on the period and the century when they were made. It is not hard to use – READ and familiarize yourself with the process before jumping right in to ensure you have success. It states in the directions that the resin should cure for a few days before using.įollow the EnviroTex directions to the letter. In the morning the resin was hard and shiny. Place them in a quiet room and cover them with a big box to protect them while they dry. Once I had all the pulls covered I let them dry overnight. I made small amounts and then mixed more as I needed it. If bubbles arise – gently exhale on them and they go away – like magic. It is amazing to watch the resin self level. I started in the center of a pull and worked out to each side. ![]() Then you pour it over the surface of the drawer pull. Basically you mix equal parts of the resin and hardener and mix it well – like you would cake batter –scraping the sides of the mixing container as you mix for 2 minutes. Since you have to work quickly with EnviroTex Lite, I don’t have any photos of the process. To keep the pull functioning –apply the resin thicker in the middle of the pull as it is self leveling and just make sure the area around the joint gets just a little bit to look shiny. I made this mistake on the first few I did. Important Note: When applying the EnviroTex Lite around the two ball joints that hold the handle – do it sparingly! Just add a thin layer so the area will look shiny– do not make it thick or it will go into the handle attachment and keep the handle from moving when it dries as well as fill in the screw hole on the back. ![]() Make sure the toothpicks are angled up and not touching the sides of the pulls. ![]() Place a toothpick into one or both of the ball joints so the handle will stay up. ( Lyn – a reader left a comment saying that sugar cubes make perfect blocks to place the handles on – Thanks Lyn for that great tip) Use little blocks of wood or wax/plastic wrap covered foam blocks so the pulls can easily be removed from the blocks when they are dry. It was not hard to remove, but one extra step. I used foam, but some of it stuck to the back when the resin was dry and I needed sand paper to remove it. Each pull needs to be placed on a block so the EnviroTex Lite can run off it. The Best DIY Chalk Paint Recipe For Painting Furniture.Chalk Paint Furniture Before & After Makeovers.Tips That Will Make Paint Clean Up… Easy!.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |